WolfVision VZ-8plus Instrukcja Użytkownika Strona 1

RINSTRUCTIONSBEDIENUNGSANLEITUNGVZ-8plusEnglish / Deutsch

Technical data:Changing the lamp of the Visualizer:1. Remove the power cord of the Visualizer.2. Remove lamp housing glass. (1 Screw)3. Remove t

PRECAUTIONSManufacturer: WolfVision GmbH, Vlbg. Wirtschaftspark, A-6840 Götzis, AustriaTel. ++43-(0)5523-52250-0, Fax ++43-(0)5523-52249E-Mail: wolfv

Connectors (3): 1 Camera head 2 Light 3 Connectors (on the back as shown below) 4 Working surface 5 Power on/off key 6 Light key (A

The RGBHV- and DVI-output (#13 and #12) can output signals in the following formats: - SXGA (1280x1024 pixel) at 60Hz- XGA (1024x768 pixel) at 75Hz (d

Shooting area on the working surface:Shooting area outside of the working surface:Turning the light backwardsIn order to enable recordings with illumi

7Slide DrawerPreset FunctionText EnhancementcameraheadslideFirst make sure that you remove any object from the working surface (very important!). Then

USB-PORTThe USB output of the VZ-8plus can be used to transfer Visualizer images onto a computer in just 2 seconds. No additional computer hardware (l

RESET OF ON-SCREEN MENU SETTINGSAll settings in the on-screen menu can be set back to the factory defaults. "Reset" is one item in the on-sc

DVI PORT Pin 24Pin 8 1 - T.M.D.S. Data2- 2 - T.M.D.S. Data2+ 3 - T.M.D.S. Data2/4 Shield 4 - T.M.D.S. Data4- (not used) 5 - T.M.D.S. Da